Best iPhone 18 Pro Max Charger? UGREEN Air 65W Mini Review

Affiliate disclosure: As an Amazon Associate I earn from qualifying purchases. Amazon links in this article are affiliate links.

If you want a tiny charger that can unlock the iPhone 18 Pro Max’s highest measured charging power, the UGREEN Nexode Air 65W Mini deserves a place on your shortlist. The version I tested combines USB PD 3.2 AVS support with a 76 g body and excellent efficiency. There is, however, one buying detail you really need to check: UGREEN has sold technically different versions under the same name.

My recommendation applies to Version 3, the unit behind the measurements in this review. It sustained 65 W for three hours and averaged 91.2% efficiency across twelve test points. Those results make it one of my strongest compact single-port recommendations, rather than a blanket endorsement of every Nexode Air 65W Mini on sale.

Looking for the orange Nexode Air 65W Mini?
Check the current offer, then confirm the hardware revision before ordering.

Check price on Amazon

Affiliate link. The listing and colour alone do not guarantee Version 3. Plug type and specifications may differ between markets.

 

Why it makes sense for the iPhone 18 Pro Max

A bigger wattage number does not automatically make an iPhone charge faster. In my separate iPhone 18 Pro Max analysis, suitable AVS chargers delivered roughly 51–53 W at the phone. Conventional USB PD chargers without the required AVS mode topped out at around 43–45 W, even when their rated output was much higher.

The useful feature here is AVS in the Standard Power Range, with a 9–20 V range. The tested UGREEN supports this at up to 3 A. That covers the approximately 17.4 V and 3 A operating point used by the iPhone at peak power. AVS support in the Extended Power Range alone did not provide the same result in my phone testing.

iPhone 18 Pro Max Charging Test: Do You Really Need a USB PD 3.2 AVS Charger?

This is why I would consider the right UGREEN revision before buying a much larger 100 W or 140 W adapter solely for this phone. Its protocol support matters more than unused power headroom.

For context, the separate 60 W AVS charging test reached approximately 50% after 15 minutes, 82% after 30 minutes and a full charge in around 70 minutes. These are reference results from that phone test, not a new full charging run performed with the UGREEN sample. Temperature, starting charge and phone use can change the outcome.

Read the full iPhone 18 Pro Max charging test on Charge-Test

 

Check the hardware revision before buying

After the original review, a comparison with another tester, Jan, revealed three versions with the same product name and model number. The differences affect charging protocols and sustained output. Version 1 does not have AVS at all, which makes it a materially different choice for an iPhone 18 Pro Max.

Feature Version 1 Version 2 Version 3
Rated output 65 W 65 W 65 W
PPS 5–11 V Up to 4.5 A Up to 5 A Up to 5 A
PPS 5–21 V No No Up to 3.25 A
SPR AVS / USB PD 3.2 No Yes Yes
Sustained 65 W in reported tests Not maintained Not maintained Maintained
Reported weight Approx. 82 g Approx. 82 g 76 g

 

The efficiency and voltage results below belong to Version 3. I do not have equivalent efficiency measurements for both earlier revisions, so you should not assume they achieve the same figures. The sustained-load findings for the earlier units come from the follow-up comparison with Jan.

My original sample was the Honkai: Star Rail Edition, chosen for its design. I later bought an orange unit (check the Amazon offer; affiliate link) and also identified it as Version 3. In the July 2026 follow-up, black and silver stock appeared more likely to include earlier revisions. That was a snapshot of stock at the time, not a reliable promise about what any seller ships today.

The roughly 76 g weight is a useful clue. A USB-C protocol tester showing both the 5–21 V PPS range and SPR AVS gives you better evidence than the colour alone. If you cannot test it yourself, ask the seller to confirm those exact profiles and the revision. The name “Nexode Air 65W Mini” is not enough.

 

A genuinely small travel companion

The housing measures 30.6 × 33 × 35.7 mm, excluding the plug pins. That works out to about 36 cm³. In the comparison set used here, it is the smallest charger by reported volume. At 76 g it is also very light, although the 72 g Rollingsquare Supertiny is slightly lighter.

Compared with the Supertiny’s 46 cm³, the UGREEN body occupies roughly 22% less volume. It also takes substantially less space than the Apple 40W Dynamic Power Adapter with 60W Max listed at 86.6 cm³ in my comparison data. These are comparisons between the tested models, not a claim about every regional plug variant or every charger on the market.

Build quality is reassuringly solid. The compromise is straightforward: you get exactly one USB-C port. If you regularly charge your phone and another device together, a larger multiport charger is more convenient.

 

USB PD profiles and Android compatibility

The USB-C port supplies up to 65 W through USB Power Delivery. Unlike some compact competitors, it also includes a fixed 12 V output profile. That is useful for certain accessories, even though it is not the reason to buy this charger for an iPhone.

Mode Available output on the tested Version 3
Fixed USB PD 5 V / 3 A, 9 V / 3 A, 12 V / 3 A, 15 V / 3 A, 20 V / 3.25 A
PPS 5–11 V at up to 5 A; 5–21 V at up to 3.25 A
SPR AVS 9–20 V at up to 3 A

 

The broad PPS support also makes Version 3 useful beyond Apple devices. The 5 A range supports the requirements of compatible Samsung phones with 45 W charging, while the wider voltage range is useful for supported Google Pixel models. Actual charging power still depends on the phone and cable. PPS and AVS are separate features; strong PPS support alone does not establish the iPhone’s AVS compatibility.

For the iPhone’s approximately 52 W AVS operating point, a suitable 60 W USB-C to USB-C cable is sufficient because the current remains at 3 A. Drawing the charger’s full 65 W at 20 V requires more than 3 A, so use an electronically marked 5 A cable for that. A 5 A cable is also required when a compatible Samsung phone requests more than 3 A through PPS.

The 65 W fixed output also covers many USB-C laptops, including typical lightweight notebook use. It is a practical option if you want to use one small adapter for your phone and laptop at different times. It cannot power both simultaneously, and more demanding laptops may need a higher-power supply.

 

Three hours at 65 W

Miniature chargers can look impressive until sustained load exposes their limits. My Version 3 sample delivered its full 65 W continuously for three hours, without shutdowns or throttling during that test.

The thermal camera recorded a maximum surface temperature of approximately 75°C. That is hot to the touch, so the small size should not be mistaken for cool operation at full output. The positive result is that the charger maintained its output throughout the test. It does not establish identical behaviour in hotter environments or with earlier revisions.

 

Standby consumption

With no device connected, the measured draw was approximately 0.1 W. Leaving it plugged in continuously at that rate would use about 0.88 kWh over a year. It is a low idle figure, although the absolute saving compared with another efficient charger is modest.

 

Efficiency across twelve load points

Efficiency tells you how much of the power drawn from the wall reaches the USB output. I calculate it as USB output power divided by AC input power. A higher value means less power is lost inside the adapter, but it does not directly measure how much energy ends up stored in the phone battery.

The Nexode Air 65W Mini achieved 85.8% to 92.6% across the supplied measurements. The arithmetic mean of all twelve load points is 91.2%. Each point receives equal weight in that average; it is not an average weighted by the time an iPhone spends at each charging stage.

Test point USB output AC input Efficiency
5 V / 1 A 5.20 W 6.06 W 85.8%
9 V / 3 A 26.87 W 29.20 W 92.0%
15 V / 3 A 45.00 W 48.59 W 92.6%
20 V / 3 A 60.10 W 64.90 W 92.6%

 

The weakest result occurs at the lightest load. Once output rises, efficiency stays around 90% or better across the remaining test points. At the 60.10 W output point, the difference between input and output is 4.80 W. This helps explain how such a small adapter can sustain a substantial load, although its limited surface area still gets hot.

These are fixed-voltage tests. They do not provide a separate efficiency measurement at the iPhone’s approximately 17.4 V AVS operating point. The full load-point chart accompanies this article as a separate image.

 

How it compares with other chargers

In the supplied comparison set, the UGREEN Version 3 has the highest reported average efficiency at 91.2%. Apple’s 40W Dynamic Power Adapter with 60W Max follows at 90.8%, then the Anker A121A Nano 70W at 90.2%. The Anker Nano II 65W records 89.3%.

The lead over the Apple adapter is only 0.4 percentage points. Without measurement uncertainty figures, I would not present that small gap as a decisive real-world advantage on its own. The stronger argument for the UGREEN is the combination of high efficiency, small size and the required AVS support.

The comparison chart reproduces the reported averages from the workbook. They are useful for orientation, but they are not a matched iPhone charging-cycle test across every charger. Port count and capabilities also differ: the Anker A121A, for example, gives you three ports instead of one.

Read the Anker Nano 70W A121A review on Charge-Test

 

Voltage stability from zero to three amps

The output-voltage measurements are a load sweep rather than a recording over time. At 5 V, voltage rises slightly from 5.155 V with no load to 5.228 V at 3 A. At 9 V, it falls from 9.015 V to 8.929 V. The 20 V output moves from 19.996 V to 19.910 V over the same current range.

All measured points stay inside the reference limits recorded in the workbook. The separate three-panel chart keeps the voltage scales distinct so you can see the small changes without mixing 5 V, 9 V and 20 V on one compressed axis. These readings show good static voltage regulation; they are not ripple or transient-response measurements.

 

Is it the best charger for iPhone 18 Pro Max

For a compact single-port adapter, the tested Version 3 is one of my best picks. You get the SPR AVS profile needed for the phone’s highest measured charging power, very good conversion efficiency and a body small enough to carry without thinking about it. It also proved capable of sustained 65 W output for laptop use.

The main reservation is the confusing revision situation. I would happily recommend the unit I tested, but I would not buy an unverified sample purely because it has the same name. Version 1 lacks AVS, and the earlier revisions did not match the sustained-load performance reported for Version 3.

There is also no need to replace a good existing USB PD charger just to chase a higher peak number. AVS is most relevant to short top-ups. The separate phone tests show that charging slows substantially near full, so a roughly 52 W peak does not translate into that power throughout a complete charge.

If you are buying a new charger, can confirm Version 3 and only need one port, the Nexode Air 65W Mini is an excellent match for the iPhone 18 Pro Max. If you need simultaneous charging, choose a multiport design instead.

View the UGREEN Nexode Air 65W Mini on Amazon

Affiliate link. Before ordering, confirm Version 3 with 5–21 V PPS and 9–20 V SPR AVS, and check that the plug type suits your country.

Pros

  • Very compact 36 cm³ housing and low 76 g weight
  • USB PD 3.2 SPR AVS plus broad PPS support on Version 3
  • 91.2% average efficiency across twelve measured load points
  • Sustained 65 W output for three hours in the tested sample
  • Low idle draw and stable voltage under the measured loads

Cons

  • Different hardware revisions share the same name and model number
  • Only one USB-C port
  • Approximately 75°C surface temperature under sustained full load

 

Michael Barton
Michael Barton is a Germany-based technology enthusiast and the sole author behind Charge-Test.com. With formal training in electrical engineering and years of practical testing experience, he focuses on real-world measurements of chargers, power banks and battery systems. His articles combine structured testing methodology with a practical, hands-on approach, always independent and free from paid review agreements.

Related Posts

LiThink 12V 100Ah TM Review: Capacity Tested, Bluetooth & Self-Heating

A 100Ah battery is only useful if it delivers that capacity under load. The LiThink 12V 100Ah TM does: across five discharge tests at...

CUKTECH 15 SE (PB200) Review: 65W Power Bank with PPS and UFCS at an Outstanding Price

With the CUKTECH 15 SE (PB200), CUKTECH delivers a surprisingly powerful power bank that stands out primarily for its outstanding price-to-performance ratio. A 20,000...

UGREEN Nexode Pro 160W Review: Five Ports, a Smart Display and 140W Tested

.ct-ugreen-review{--ct-accent:#f58220;color:inherit;line-height:1.7}.ct-ugreen-review h2,.ct-ugreen-review h3{scroll-margin-top:90px}.ct-ugreen-review h2{margin-top:2em;line-height:1.3}.ct-ugreen-review h3{margin-top:1.6em;line-height:1.35}.ct-ugreen-review a{color:inherit;text-decoration:underline;text-decoration-color:#f58220;text-underline-offset:3px}.ct-ugreen-review a:hover{color:#9b4200}.ct-ugreen-review a:focus-visible,.ct-ugreen-review .ct-table-scroll:focus-visible{outline:2px solid #c75a00;outline-offset:4px}.ct-ugreen-review .ct-disclosure{color:#596167;font-size:.94em}.ct-ugreen-review .ct-reading-note{border-left:4px solid #f58220;padding:12px 16px;background:#fff6ed;color:#24282a}.ct-ugreen-review .ct-chart{margin:26px 0}.ct-ugreen-review .ct-chart a{display:block}.ct-ugreen-review .ct-table caption{caption-side:top}.ct-ugreen-review .ct-table tbody...

Sandberg All-in-1 Powerbank 27000 PD 240W Review – USB PD 3.2 with AVS Support

With the All-in-1 Powerbank 27000 PD 240W, Sandberg enters the high-performance power bank segment. On paper, this model directly targets flagship devices from brands...

Anker SOLIX C300 Review: Compact Power Station with Impressive Output and 140W USB-C Ports

With the SOLIX C300, Anker introduces a highly compelling compact power station that positions itself somewhere between a high-capacity power bank and a fully...