Marketing claim: 4255 mWh. Measured reality: barely over half of that. Here’s what the lab data shows.
PUJIMAX is one of those budget brands you stumble across while scrolling through AliExpress at midnight, and a while back we put their AAA cells on the bench. They were cheap, and they performed about how you’d expect cheap cells to perform.
Now the company has expanded into lithium-based AA batteries, and this time they’re swinging for the fences with the spec sheet. The headline number? A claimed 4255 mWh per cell.
If that figure held up, these would be among the highest-capacity lithium AA cells money can buy. Naturally, that’s exactly the kind of claim that belongs on a test bench rather than in a shopping cart. So let’s find out whether PUJIMAX delivered a class leader or another exercise in optimistic labeling.
What You Get in the Box
These are standard AA cells, so the physical dimensions are fixed by the form factor — nothing surprising there. Each cell tips the scale at roughly 19 grams, which is right in the expected range for a lithium AA battery.
Visually, PUJIMAX went with a green wrap that genuinely stands out from the sea of blue and black cells. The set I ordered was the bare-bones option: four cells, no charger included.
One practical note before we go further. These cells work with any standard lithium AA charger. The SkyRC MC3000 I rely on for testing cannot charge them — I use it strictly for capacity measurement, not for topping them up.
Why Bother With Lithium AA Batteries at All?
If you’ve been using rechargeables for years, it’s a fair question: why reach for a lithium AA when trusty Ni-MH cells have done the job for decades? Two technical advantages explain the appeal.
A Genuine 1.5-Volt Output
The big one is voltage. A conventional Ni-MH cell puts out only 1.2 V, and in plenty of devices that lower voltage shows up as reduced performance or as a premature “battery empty” warning even when there’s juice left in the tank. Lithium AA cells like the PUJIMAX run in the 1.5-volt range, which makes them a far better drop-in replacement for disposable alkalines.
There’s a caveat worth flagging, though. Unlike some lithium AA cells that actively hold the voltage at a flat, regulated level, the PUJIMAX does not regulate output to a constant value. It starts in the 1.5 V range — comfortably above Ni-MH — but the voltage sags over the discharge, behaving more like a traditional battery than a regulated one.
Built-In Protection Against Deep Discharge
The second advantage is the integrated protection circuit, which reliably prevents deep discharge. Once the charge level drops below a critical threshold, the cell simply shuts itself off. With Ni-MH cells, the device’s own circuitry can drag the cells well below 1 V — a common scenario in flashlights or decorative string lights — and that kind of deep discharge is harmful, shortening Ni-MH lifespan considerably. Lithium AA cells sidestep this by design, which tends to give them a longer effective service life.
The Trade-Offs Nobody Mentions in the Listing
The upsides are real, but lithium AA cells come with strings attached that the product page conveniently glosses over.
All That Electronics Has a Cost
A lithium cell runs at a nominal 3.6 to 3.7 V. Squeezing the required 1.5 V out of that means cramming a voltage converter into the cell, plus protection circuitry guarding against overcharge, short circuit, and deep discharge. All of that hardware has to fit inside the cramped shell of an AA cell — which is precisely why lithium AA cells are more complex to build and usually pricier than a simple Ni-MH cell.
More Capacity? Not Necessarily
Here’s a myth worth puncturing: lithium does not automatically mean more capacity, at least not in the AA form factor. The space eaten up by the converter and protection board comes straight out of the usable cell capacity. In the best case, a lithium AA matches a good Ni-MH cell — don’t go in expecting a dramatic leap.
Why Lithium Cells Are Rated in mWh, Not mAh
Shop for lithium AA cells and you’ll notice the capacity is quoted in mWh (milliwatt-hours) rather than the mAh (milliamp-hours) you’re used to. There’s a sound reason for that.
An mAh figure tells you how long a cell can deliver a given current, regardless of operating voltage. But because Ni-MH runs at 1.2 V and lithium AA runs at 1.5 V, comparing raw mAh across the two would be misleading: identical mAh values store different amounts of energy at different voltages.
The mWh rating fixes this by folding voltage and charge into a single number (mWh = mAh × voltage). A 2,900 mAh Ni-MH cell at 1.2 V works out to roughly 3,480 mWh. A lithium cell with the same 2,900 mAh at 1.5 V lands around 4,350 mWh — noticeably more stored energy. So when you’re comparing across battery chemistries, mWh is the figure to trust.
How We Test at Charge-Test.com
Every PUJIMAX cell ran through the proven SkyRC MC3000 charger and analyzer. Each was discharged at three different currents — 0.1 A, 0.4 A, and 1.0 A — so we can map behavior under light load as well as moderate and heavier draw (think flashlights and wireless mice).
To expose manufacturing variation between cells, all four batteries from the pack were tested individually and the results compared side by side.
The Verdict on Capacity
PUJIMAX rates these at 4255 mWh, which would be genuinely impressive. So what did the cells actually deliver in practice?
Measured capacity in mAh
| Cell | 0.1 A | 0.4 A | 1 A |
| Cell 1 | 1729 | 1650 | 1526 |
| Cell 2 | 1725 | 1669 | 1480 |
| Cell 3 | 1629 | 1646 | 1531 |
| Cell 4 | 1772 | 1676 | 1546 |
| Average | 1714 | 1660 | 1521 |
Measured capacity in mWh
| Cell | 0.1 A | 0.4 A | 1 A |
| Cell 1 | 2412 | 2296 | 2128 |
| Cell 2 | 2448 | 2296 | 1936 |
| Cell 3 | 2291 | 2269 | 2030 |
| Cell 4 | 2477 | 2336 | 2139 |
| Average | 2407 | 2299 | 2058 |
Well. That didn’t go to plan.
At 0.1 A the cells averaged 2407 mWh (1714 mAh). At 0.4 A, 2299 mWh (1660 mAh). At 1 A, 2058 mWh (1521 mAh).
For a battery advertised at 4255 mWh, that’s an inexcusably poor showing — the best-case result is roughly 43% below the printed claim. There honestly isn’t much more to say about it.
How It Stacks Up Against the Competition
Lined up against the other lithium AA cells we’ve measured, the PUJIMAX sits firmly at the bottom of the table (averages in mWh):
| Battery | 0.1 A | 0.4 A | 1 A | Avg |
| Delyeepow USB-C AA | 1803 | 1732 | 1607 | 1714 |
| EBL Lithium AA USB | 2327 | 2222 | 2044 | 2197 |
| PUJIMAX AA 4255 mWh | 2407 | 2299 | 2058 | 2255 |
| ANSMANN Premium Rechargeable AA | 2387 | 2436 | 2198 | 2340 |
| MAOMAOCON 3000 mWh | 2715 | 2743 | 2415 | 2624 |
| Zepath AA 3000 mWh | 2748 | 2756 | 2470 | 2658 |
| Linogy 3600 mWh | 2898 | 2885 | 2609 | 2797 |
| Hixon AA 3500 mWh (Red) | 2761 | 2946 | 2777 | 2828 |
| Dracutum 3600 mWh | 2942 | 2876 | 2675 | 2831 |
| EBL Lithium AA 3600 mWh | 2979 | 2919 | 2623 | 2840 |
| tka AA 3000 mWh USB-C | 2997 | 2903 | 2637 | 2846 |
| EBL Lithium 3000 mWh | 3183 | 3166 | 2472 | 2940 |
| Zepath AA 3600 mWh | 3108 | 3169 | 2832 | 3036 |
| BATZONE Lithium AA | 3135 | 3212 | 3018 | 3122 |
| UseNiy 3600 mWh | 3160 | 3254 | 3072 | 3162 |
| Hixon AA 3500 mWh (Blue) | 3368 | 3456 | 3194 | 3339 |
| XTAR AA Lithium 4150 mWh / 2500 mAh | 3381 | 3583 | 3297 | 3420 |
To put it bluntly: this is one of the weakest results I’ve recorded from any lithium AA cell to date.
Voltage Behavior Under Load
The capacity verdict is already in, but the discharge curve is still worth a look. The PUJIMAX was logged at 1 A on the MC3000, and the voltage trend looks like this:
| Elapsed time | Voltage (V) |
| 00:00 (start) | 1.526 |
| 00:30:00 | 1.479 |
| 01:00:00 | 1.460 |
| 01:30:00 | 1.436 |
| 02:00:00 | 1.413 |
| 02:30:00 | 1.378 |
| 03:00:00 | 1.346 |
| 03:30:00 | 1.318 |
| 04:00:00 | 1.270 |
| 04:08:00 | ~1.19 |
| 04:11:31 (cutoff) | 1.101 |
Voltage ranges from 1.526 V at full charge down to about 1.1 V when empty. Lithium AA cells generally fall into two camps: those that hold a constant, regulated voltage, and those that try to mimic the gradual decline of a conventional battery. The PUJIMAX belongs to the second group — a steady, predictable slope rather than a flat line.
Conclusion: Save Your Money
There’s not much to spin here. The facts speak for themselves, and unfortunately they speak against this battery.
PUJIMAX markets these cells at 4255 mWh. In testing they managed just 2407 mWh at 0.1 A — about 43% short of the promise — and under 1 A load capacity slid to 2058 mWh. That puts the PUJIMAX among the worst-performing lithium AA cells I’ve tested.
The discharge curve itself is perfectly reasonable, but a clean voltage profile can’t rescue a cell that delivers barely half its advertised energy.
My recommendation: steer clear. There are plenty of alternatives — several of them in the comparison table above — that honor their stated capacity far more honestly.





